2. Open AMI Supervisor Monitoring Software:
- In the AMI application, go to Application > Configure > Treater > DataIO Serial.
Select COM Port:
- Under DataIO Serial, locate and select the relevant COM Port (e.g., COM Port X).
- Important: The COM port specified in the application may differ from the COM port in Device Manager.
- Go to DataIO_Serial > Com Port # > Com Port to ensure the correct COM port is selected (refer to Figures 3 & 4 for guidance).
1. Specify Channels:
- Once the correct COM port is set, select the channels to be sent over the output data stream.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article